How to Assemble the T umble T Wire Spool Rack
Steps 6-10
Step 6
- Turn the T umble T Wire Spool Rack upside down and insert the foot pads into the hanger slots or
foot pad slots.
Step 7
- Place the T umble T Wire Spool Rack on a flat surface (feet down)
- While applying slight pressure on bar #7, tighten all bolts on both sides.
Step 8
- Take the 2 remaining tubes, place a finder washer on one end with a 1/4" x 1/2" flange bolt
- Insert the tubes through each "T" on one end plate while the washer on the side of the rack.
Step 9
- Place 4 of the remaining 5" PVC rollers on 1 tube inside the end plates.
- When the rollers are on, slide the end through the other "T".
- Repeat for remaining tube.
Step 10
- Attach a fender washer with a 1/4" x 1/2" bolt to the remaining ends.
- At this time it will take 2 wrenches, one on each end, to tighten the bolts.